Atolla AT-U06TM review

A supplied-power package with a longer stated lead

The Atolla AT-U06TM is an earlier documented hub package for four Type-A data devices. Its useful combination is individual port switching, a separate charging socket, a 100cm computer lead and an included 5V/3A power adapter. Those package details distinguish it from superficially similar Atolla hubs.

Use the exact SKU when comparing an offer. A matching brand and general four-port description do not establish the same cable length, enclosure or included supply. This page describes the preserved AT-U06TM specification rather than assuming every later Atolla package is identical.

Four data sockets and a different fifth connection

The original manufacturer description specifies four USB 3 Type-A data ports at an advertised 5Gbps. A separate Smart Charging socket supplies compatible USB-powered equipment. That fifth socket does not add a fifth peripheral data connection to the computer.

This distinction matters if every socket has already been allocated to a keyboard, receiver, printer and drive. A further data device needs another data output, regardless of whether the charging socket is empty. Count the functions you need rather than the number of openings in a photograph.

Individual switches help manage connected equipment

The maker describes an independent power switch for each data port. That can be convenient when the hub rests within reach and you want to stop supplying one connected device without repeatedly removing its plug. Confirm the exact unit's switch operation when comparing packages.

A switch is not a substitute for finishing an active transfer or following the operating system's removal procedure. Decide which devices benefit from independent power control and which need to stay connected continuously. Useful switching depends on the workflow as well as on the hardware.

The adapter supports peripherals rather than laptop charging

The preserved package includes a 5V/3A hub adapter, a 15W supply rating. The separate charging socket is advertised up to 2.4A for compatible equipment. Neither figure means that every socket receives that maximum simultaneously or that the hub can charge the host computer.

Check the actual regional plug and supplied adapter before purchase. The computer connection is Type-A, and no laptop Power Delivery route is documented. Choose a different dock if replacing the laptop's own charging connection is part of the plan.

Use the 100cm lead to plan placement

The original SKU-specific page states a 100cm computer lead. That can make the arrangement relevant when the computer socket is farther from the intended hub position than a short travel cable comfortably reaches. Measure the route with enough room for bends and strain relief.

Do not borrow that length for a neighboring Atolla hub. A different package may have a shorter attached lead or another cable arrangement. Likewise, the reviewed source does not establish detachability, so this page does not promise that the host lead can be replaced independently.

Check the reference against the actual offer

The original description names Windows, MacOSX and Linux within its stated version scope and says no extra hub driver is required. Attached peripherals can have their own software requirements. The data ports share the upstream connection, and an advertised interface rate is not a measured copying speed.

The original maker specification remains available as a cached reference while its direct address no longer provides a dependable current product page. Shortlist this earlier configuration only after checking the actual SKU and package. It is relevant for four switched Type-A data devices and the stated longer lead; choose another layout for Type-C data, displays, Ethernet or computer charging.